IBM IntelliStation M Pro 6868-5BU System Integration Manual page 22

2-4
Action
Connect the Meridien
I/O box and audio
device (888 I/O™).
Connect the monitors.
Connect the disk
drives.
Connect all power
cables.
Change the BIOS and
install the Avid disk
image.
Install and verify the
Avid software.
Test the system.
Create disks for
troubleshooting the
system at a later date.
System Overview
Table 2-1 Hardware Integration Check List (Continued)
Explanation
Connect the Meridien I/O box to the system. See"Connecting the Meridien
I/O Box" on page 5-3. Use the setup guide for your system to connect the
audio device (888 I/O) to the Meridien I/O box.
Connect the monitors to the Meridien display controller board. See
"Connecting the Display Monitors" on page 5-4.
Connect the drives to the SCSI board or the Fibre Channel (F/C) board. The
drive types and how they are configured depend on the customer order. See
the setup guide for the specific drives you are using.
Make sure the power cables are connected to each device, including disk
drives.
Chapter 6, "Changing the System BIOS Settings" on page 6-3 explains how to
change the BIOS and "Installing the Windows NT Image" on page 6-5
explains how to create a new disk image that contains a system with almost
all the Windows NT features installed.
Chapter 7 explains:
• How to install the Avid software.
• How to verify the installation of all drivers.
Test the system to see if the integration went properly. See "Testing the
System" on page 7-15.
See "Creating Troubleshooting Disks" on page 7-17.