Table of Contents
Advertisement
c
When you install the fan assembly, make sure the foam strip located
on the fan assembly captures the PC board in the last slot. The foam
strip should not push the board outward, but should secure it in
place.
6. Using a Phillips screwdriver, tighten the captive screws on the fan
assembly one more ¼-turn.
7. Plug the 12-V power connector from the fan assembly into one of
the 12-V power connectors used for drives at the top front of the
chassis (see Figure 4-17).
Figure 4-17 Power Connector
8. Replace the left side panel of the system and return the system to
the upright position.
9. Reconnect system power and turn on all peripherals.
10. Turn the system on.
11. Listen for the fan noise to make sure the fan is working.
4-23
Power
connector
Installing the Fan Kit
Advertisement
Table of Contents
Troubleshooting
