Installing The Coin Mechanism - Keurig B3000 Service Manual

Installing the Coin Mechanism:

The step by step procedure for installing the coin changer is as follows:
1. Unlock the coin changer cabinet fascia [Figure 11] and remove it by lifting up at coin retrieval
opening [Figure 12]. Remove the top panel of the coin changer cabinet by unscrewing the two
screws at the rear of the unit [Figure 13] and sliding the panel rearward and lifting up.
Figure 11
2. Mount and connect the coin mechanism.
Figure 14
Locate the mounting
screws of the cabinet
shown in fig 14.
Coin
retrieval
opening
Figure 12
Figure 15
Slide coin mechanism
back into the cabinet
insuring the cabinet
mounting screws locate
into the holes at the
back of the unit shown
in fig 15. Note, some
changers may require a
slight deflection of the
cabinet side panels
during insertion.
B3000 SERVICE MANUAL
60-200807-000, REV C
Figure 16
Once the coin
mechanism is seated
properly connect the
unit to the connector as
shown and route cord
as shown in fig 16.
Figure 13
Figure 17
Replace the top panel.
When mounted properly
the coin mechanism should
have a flush look and feel
as shown in fig 17.
77