How To Start The Calibration - Fluke ScopeMeter 190 II Series Service Manual

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual

How to Start the Calibration

To start the calibration:
1. Power the Test Tool with the power adapter input and the BC190 power
adapter.
2. Check the actual Test Tool date and adjust the date if necessary (the
calibration date will become the Test Tool date when saving the calibration
data):
a. Press
b. Press
c. Use
d. Press
e. If necessary, adjust the date with
3. Select the calibration mode.
The Calibration Adjustment Procedure uses built-in calibration setups that
can be accessed in the calibration mode.
To enter the calibration mode proceed as follows:
•
The display shows the
The display shows the calibration step
status
Continue as indicated in the Calibration Procedure Steps section.
You can exit the calibration mode without changing the calibration data by turning
the Test Tool off.
5-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(toggles the menu bar on and off).
USER
F1
to open the
to select the
DATE ADJUST
ENTER to open the
selections and leave the menu.
Press and hold , press and release
USER
CAL MODE
or
:IDLE (valid) :IDLE (invalid)
menu.
OPTIONS
... option.
menu.
DATE ADJUST
. Press ENTER
CLEAR , and release
(Calibration Adjustment) screen.
WarmingUp (CL 0200)
, and the softkey menu.
to activate all
.
USER
, the calibration