Furuno 1824C-BB Installation Manual page 50

29. If you are going to use the equipment as a remote display, choose MONITOR
MODE and then press the C: EDIT soft key. If not, go to step 31.
MONITOR MODE
ON
OFF
30. Choose ON and then press the C: ENTER soft key.
• TX blanking function is not available when the MONITOR MODE is ON. To set a TX
blanking sector, select OFF from MONITOR MODE on the NavNet equipment, and
then set the sector same as the main radar. Finally, set MONITOR MODE to ON.
• When the MONITOR MODE is ON, the following functions are not available.
• Tuning (auto/manual, on the RADAR SETUP menu)
• Antenna rotation (RADAR SETUP menu)
• TX sector blanking (RADAR DISPLAY SETUP menu)
• Watchman (RADAR DISPLAY SETUP menu)
• Pulse select (Soft key)
31. Choose HEADING ADJUST and then press the C: EDIT soft key.
HEADING ADJUST
ON
OFF
32. Choose ON and then press the C: ENTER soft key.
You have mounted the antenna unit facing straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead ahead visually should appear on the
heading line (zero degrees).
In practice, you will probably observe some small error on the display because of the
difficulty in achieving accurate initial positioning of the antenna unit. The following
adjustment will compensate for this error.
a) Set ship's heading toward a suitable target (for example, ship or buoy) at a range
between 0.125 and 0.25 nautical mile.
b) Rotate the ENTER knob to bisect the target with the EBL.
c) Press the ENTER soft key.
d) As a final test, move the boat towards a small buoy and confirm that the buoy shows up
dead ahead on the radar when it is visually dead ahead.
3-6