Furuno 1824C-BB Installation Manual page 21

12. Pass the cable from the rotation detector through two cable clamps.
Cable tie
(Another should
be inside.)
13. Follow the instructions on the label inside the mounting base to secure the snap assy.
14. Confirm that the rubber gasket is properly positioned and that the triangle mark on the
radome cover is aligned with the triangle mark on the mounting base, then tighten the
fixing screws for the cover. See the sectional view on page 1-9 for how to position the
rubber gasket.
Mounting the optional mounting bracket
A mounting bracket for fastening the antenna unit to a mast on a sailboat is optionally
available.
Contents of mounting bracket 2 kit Type: OP03-93, Code No.: 008-445-080
Part
Hex. bolt
Hex. bolt
Mounting plate
Support plate (1)
Support plate (2)
Bracket (1)
Bracket (2)
Fixing plate
Assemble the mounting bracket and fasten it to a mast. Fasten the antenna unit to the
bracket. For details, see the figure on the next page.
Rotation detector
Cable clamps
Antenna unit, clamping the rotation detector cable
M4x12
M8x20
03-018-9001-0
03-018-9005-0
03-018-9006-0
03-028-9101-0
03-028-9102-0
03-028-9103-0
Type
000-804-725
000-805-707
100-206-740
100-206-780
100-206-790
100-206-810
100-206-820
100-206-830
1-11
Code No. Qty
4
8
1
1
1
1
1
2