Furuno 1824C-BB Installation Manual page 47

11. Choose appropriate item and then press the C: EDIT soft key. One of the following
displays appears depending on your selection.
DEVICE NUMBER
1 (IP:172.031.003.001)
2 (IP:172.031.003.002)
3 (IP:172.031.003.003)
4 (IP:172.031.003.004)
SOUNDER SOURCE
ETR0 (IP:172.031.092.001)
ETR1 (IP:172.031.092.011)
ETR2 (IP:172.031.092.012)
ETR3 (IP:172.031.092.013)
ETR4 (IP:172.031.092.014)
ETR5 (IP:172.031.092.015)
ETR6 (IP:172.031.092.016)
ETR7 (IP:172.031.092.017)
ETR8 (IP:172.031.092.018)
ETR9 (IP:172.031.092.019)
OFF
12. Choose appropriate setting and then press the C: ENTER soft key.
If you set DEVICE NO. or RADAR SERVICE, turn the power on and off again at the
completion of the installation wizard.
13. After choosing ALL sources, press the A: NEXT soft key, and the RADAR SETUP menu
appears. If you do not have a radar installed, go to step 33.
ANTENNA TYPE
HEADING DATA
ANTENNA ROTATION
RADAR OPTIMIZATION
TIMING ADJUST
M. B. SUPRRESSION
RADAR ANTENNA HEIGHT
STC CURVE
MONITOR MODE
HEADING ADJUST
Installation wizard, radar setup
14. Choose ANTENNA TYPE and then press the C: EDIT soft key.
ANTENNA TYPE
A (MODEL 1824C-BB)
B (MODEL 1834C-BB)
C (MODEL 1934C-BB)
D (MODEL 1944C-BB)
E (MODEL 1954C-BB)
F (MODEL 1964C-BB)
15. Choose the appropriate antenna type and then press the C: ENTER soft key.
RADAR SOURCE
1 (IP:172.031.003.001)
2 (IP:172.031.003.002)
3 (IP:172.031.003.003)
4 (IP:172.031.003.004)
NO CONNECT
AUX SOURCE
AUX1 (IP:172.031.008.001)
AUX2 (IP:172.031.008.002)
AUX3 (IP:172.031.008.003)
AUX4 (IP:172.031.008.004)
OFF
A
MAGNETIC
ROTATE
OFF
OFF
OFF
MEDIUM (3-10m, 10-33ft)
MEDIUM
OFF
OFF
3-3