Advertisement
3.3.1 Install the oil reservoir or jug (JIB)
Remove the original lid from the oil container and foil liner. Replace with the provided cap, which
has connected suction hardware. Ensure the feeder tube from the cap reaches to the bottom of
the oil container.
Place the oil container inside the cabinet and slide it into place (as shown on the following page).
Avoid catching the suction hardware on the cabinet interior as the container is placed in the fryer.
The system is now ready for operation.
3.3.2
Changing the JIB (Jug In Box)
oil reservoir
When the oil reservoir level is low and
displays TOP OFF OIL EMPTY, (see Figure 2).
Press the check button to clear the screen.
Once the reservoir is refilled and/or
replaced, press and hold the orange reset
button next to the oil reservoir (see Figure 7
on the following page) until the message in
the lower corner is no longer displayed. If
using solid shortening, see Appendix B for
instructions.
1. Open the cabinet and slide the JIB from
the cabinet (see Figure 3).
Figure 3
3. With the replacement jug upright remove
the cap and foil seal (see Figure 5).
Figure 5
Top Off Oil Empty indicates that the oil reservoir is
empty.
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 4).
4. Put the tube in the new full container (see Figure 6).
3–4
Figure 2
Figure 4
Figure 6
Advertisement
Troubleshooting
