Advertisement
FILTERQUICK™ FQE30-T ELECTRIC FRYER
APPENDIX A: BULK OIL CONNECTION AND SETUP
NOTE: The instructions in this manual for using a bulk oil system for filling and discarding oil
are for a bulk oil system. These instructions may not be applicable to some bulk oil systems.
A.1.1 Bulk Oil Systems
Bulk oil systems have large oil
storage
tanks,
located in the rear of the
restaurant,
connected to a rear manifold
on the fryer.
pumped from the fryer, via
the fitting located on the left
of the manifold on the rear of
the fryer, to the disposal tanks and fresh oil is pumped from the tanks, through the
fitting located on the right of the manifold, to the fryer (see Figure 1). The 9-pin wire
harness allows connection to various bulk oil systems. The wiring diagram is located on
the back page.
Set the fryer to bulk through the Settings/Service mode on the far-left controller.
vats need to be idle to set these settings.
1. With the controller soft powered off press the HOME button.
2. Press the Settings button.
3. Press the Service button.
4. Enter 3000
5. Press the checkmark button.
6. Press the down arrow button.
7. Press OIL SYSTEM TYPE.
8. Press the BULK button for bulk fresh oil; if no bulk fresh oil is used, leave setting
at JIB. The type selected is highlighted.
9. The controller displays SETUP COMPLETE RESTART THE SYSTEM.
10. Press the checkmark button.
11. Press WASTE OIL.
12. Press the bulk button. The type selected is highlighted.
13. The controller displays SETUP COMPLETE RESTART THE SYSTEM.
14. Press the checkmark button.
15. Press the home button to exit.
INSTRUCTIONS
typically
that
are
Fresh Oil
Connection
Waste oil is
Figure 1
A-1
Bulk oil wiring
connection
Waste Oil
Connection
All
Advertisement
Troubleshooting
