This Is How You Install A Dmc20 - Siemens SINUMERIK 828D Series Software And Hardware Service Manual

Service cases - hardware
4.19 Hub Modules
4. First shift the mounting slide downwards at the lug
mounting rail.
Figure 4-67
5. Swivel the module to the front to remove it from the mounting rail
4.19.4

This is how you install a DMC20

Installing
Note
The 50 mm clearances above and below the components must be maintained.
Procedure:
1. Place the component on the mounting rail.
2. Then, swivel the component on the mounting rail so that the mounting catches click into
place at the rear.
3. Slide the component along the mounting rail to either the left or right up to its final position.
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cable to X520.
230
Removing the DMC20
①
to release the interlocking with the
②
.
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1