Siemens SINUMERIK 828D Series Software And Hardware Service Manual page 48

Service cases - software
3.3 Software backup
Installing the software backup
Procedure:
1. Switch-on the control again, as the backup can only be generated when the control boots.
After the control has been switched-on, the following is displayed:
1. Press the <SELECT> key, "Normal startup" is the default setting.
2. To call the "Startup menu", press the following keys in succession:
Menu reset key, HSK2 (horizontal SK2), VSK2 (vertical SK2)
Note
PPU with touch operation
To call the startup menu when powering up, there is an additional shortcut for all PPUs: "8"
→ "2" → "8"
3. The Startup menu is displayed:
48
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1