Advertisement
4
AVAYA E1/QSIG
5.0 CONFIGURING THE PBX TO INTEGRATE
The following programming is intended for certified PBX technicians/engineers.
The screens shown in this section are taken from an Avaya PBX administration
terminal. Some parameters may not appear on all software releases.
Ensure all required software features are enabled on the PBX. Access the System
Parameters Customer Options form. Below is an example of the forms required for
QSIG integration, with the required features in boldface.
Message Waiting:
For MWI the correction of PEM 171458 is necessary.
This correction is first available in Release E070V08_1_2_3.
NOTICE:
ICU Setup:
The screens in this
Config Note are only for
The QSIG Line is configured like a standard QSIG Line.
illustration purposes.
The CRC4 Check procedure was in the test case disabled !
It is recommended that
a qualified technician
review the customer's
Tenovis I-55 QSig
programming for
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
Advertisement
