Drive System Maintenance; Checking The Seat Belt; Adjusting The Tracking - Toro Z Master Professional 7500-D Series Operator's Manual

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. Engage the parking brake, shut off the engine,
and remove the key.
7. Adjust the stop plates as needed.
•
If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward
on the left T-slot until the machine tracks
straight (Figure
•
If the machine tracks to the left, loosen the
bolts and adjust the right stop plate rearward
on the right T-slot until the machine tracks
straight (Figure
8. Tighten the stop plate
Figure 51
1. Control lever
2. Bolt
-L
EUTRAL OCK
AST
51).
51).
(Figure 51).
3. Stop plate
9. Align the levers in the front-to-rear position by
bringing the levers together to the N
position, and slide them until they are aligned,
then tighten the bolts
and
10. If alignment is needed, loosen the 2
motion-control lever mounting bolts on the
misaligned side
11. Move motion-control lever to meet the opposite
side.
g254284
12. Tighten the 2 motion-control lever mounting
bolts (Figure
48
(Figure 52).
Figure 52
(Figure 53).
Figure 53
53).
EUTRAL
g009195
g254283