Using The Drive-Wheel Release Valves; Transporting - Toro Z Master Professional 7500-D Series Operator's Manual

Using the Drive-Wheel
Release Valves
Use the drive-wheel release valves to release the
hydrostatic drive system, which allows you to push the
machine without the running the engine.
Rotate each bypass valve counterclockwise 1 turn to
release; rotate each bypass valve clockwise to reset
system (Figure 34).
Important:
Do not overtighten. Do not tow the
machine.
Figure 34
1. Right bypass valve
g004644
2. Left bypass valve

Transporting

Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions. Knowing
this information could help you, your family, pets, or
bystanders avoid injury.
To transport the machine:
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. Only
use the designated tie-down locations on the
mower (Figure 35). Use these locations even
when transporting the mower with an attached
accessory. Using non-designated locations may
cause damage to the mower and/or attachment.
1. Tie-down location
•
Secure a trailer to the towing vehicle with safety
chains.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings,
or a slow moving vehicle emblem is
dangerous and can lead to accidents
causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this procedure.
Back up ramps and drive forward down ramps
36).
34
Figure 35
g225819
(Figure