Controls; Horizon Display Monitor - Toro Z Master Professional 7500-D Series Operator's Manual

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Control Panel

1. Horizon display monitor

2. Deck-left switch
Horizon Display Monitor
Refer to the Software Guide for detailed information
explaining the operator interface that allows you to
access information, reset counters, modify system
settings, and troubleshoot the equipment.
Horizon Display Monitor
1. Screen
2. LED status light
Figure 5
3. Key switch
4. PTO
Figure 6
3. Buttons
Information Screen
The information screen displays information relative
to machine operation; refer to the Software Guide for
more information.
Buttons
The multi-functional buttons are located at the bottom
of the panel. The icons displayed on the information
screen above the buttons indicate the current function.
The buttons allow you to select the engine speed and
navigate through system menus.
Refer to the Software Guide for more information.
LED Status Light
The LED status light is multi-colored to indicate the
system status and is located on the right side of the
panel. During startup, the LED illuminates red to
orange to green to verify functionality.
g225792
•
Solid green—indicates normal operating activity
•
Blinking red—indicates an active fault
•
Blinking green and orange— indicates that a
clutch reset is required
Refer to the Software Guide for more information.
Alarm
If an error occurs, an error message displays, the LED
turns red, and the alarm sounds audibly as follows:
•
A fast chirp sound indicates critical errors.
•
A slow chirping sound indicates less critical errors,
such as required maintenance or service intervals.
Note:
During startup, the alarm sounds briefly to
verify functionality.
Refer to the Software Guide for more information.
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance (Figure
Hours are displayed in Engine-Off screen or in the
Engine Hour Counter menu.
Refer to the Software Guide for more information.
g228164
Throttle Control
The throttle controls the engine speed, and there are
3 speeds: Maximum, Efficient, and Low.
Refer to the Software Guide for more information.
14
5).