Toro Z Master Professional 7500-D Series Operator's Manual page 64

7. Raise the discharge deflector (side discharge
mowers only).
8. Measure from the level surface to the front tip of
the center blade (Figure
Note:
The measurement should read 7.6 mm
(3 inches).
In most conditions, the back tips on the side
blades should be adjusted as follows:
•
Side Discharge Machines: 6.4 mm (1/4
inch) higher than the front.
•
Rear Discharge Machines: should be level
with the front.
Figure 84
1. Side Discharge: 8.3
cm (3-1/4 inches); Rear
Discharge: 7.6 cm (3
inches).
2. Rear blade tip
3. Front blade tip
9. Fine-tune the adjustment nut on the front deck
lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single-point adjustment can be utilized to gain
more adjustment.
84).
g009997
4. 7.6 cm (3 inches)
5. Level surface
(Figure 85).
1. Deck adjustment
2. Jam nut
10. Measure the rear blade tip height. Fine-tune
the rear adjusters as required; the single-point
adjustment can be utilized to gain more
adjustment.
•
Side Discharge Machines: the rear tips
of the side blades should measure 8.3 cm
(3-1/4 inches).
•
Rear Discharge Machines: the rear tips of
the side blades should measure 7.6 cm (3
inches).
11. Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck-lift arm
assemblies.
12. Lower the discharge deflector (side discharge
mowers only).
13. If the 4 deck adjusters do not have enough
adjustment to achieve the accurate height of
cut with the desired rake, you can adjust the
single-point system
64
Figure 85
3. Adjustment nut
(Figure 86).
g231991