Toro Z Master Professional 7500-D Series Operator's Manual page 10

1. Read the instructions before servicing or performing
maintenance to the machine.
2. Time interval
3. Check the engine-oil level.
4. Check the coolant level; refer to the Operator's Manual for
further instructions.
5. Check the tire pressure (2 locations).
6. Check hydraulic-fluid level; refer to the Operator's Manual
for further instructions.
126-9280
For Models with 152 cm (60-inch) or 183 cm (72-inch)
Decks with Rear Discharge
1. Belt routing
126-9351
1. Chassis (15 A)
2. Accessory (15 A)
decal126-9280
decal126-9351
3. Main (25 A)
4. Power point (15 A)
126-9279
7. Check the jackshaft-fluid level.
8. Grease the deck-drive PTO; refer to the Operator's Manual
for further instructions.
9. Check the air cleaner.
10. Grease the idler pivot; refer to the Operator's Manual for
further instructions
11. Grease the front caster wheel bearings (2 locations); refer to
the Operator's Manual for further instructions.
12. Grease the front caster pivots (2 locations); refer to the
Operator's Manual for further instructions.
For Models with 152 cm (60-inch) Decks with Side
10
126-9573
Discharge
decal126-9279
decal126-9573