Positioning The Flow Baffle - Toro Z Master Professional 7500-D Series Operator's Manual

6. If the cam locks do not lock the baffle into place
or it is too tight, loosen the lever and then rotate
the cam lock.
Note:
Adjust the cam lock until the desired
locking pressure is achieved.
Figure 29

Positioning the Flow Baffle

For Machines with Side Discharge
The following figures are only recommendations
for use. Adjustments vary by grass type, moisture
content, and the height of the grass.
Note:
If the engine power draws down and the
mower ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for
this position is as follows:
•
Short, light grass mowing conditions
•
Dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the
mower
Figure 30
Position B
Use this position when bagging. Always align it with
the blower opening.
g027727
Position C
This is the full open position. The suggested use for
this position is as follows:
•
Tall, dense grass mowing conditions
•
Wet conditions
•
Lowers the engine-power consumption
•
Allows increased ground speed in heavy conditions
g005832
31
Figure 31
Figure 32
g005833
g005834