Specifications - Toro Z Master Professional 7500-D Series Operator's Manual

Deck-Lift Switch
Press the switch rearward to raise the deck.
Press the switch forward to lower the deck.
Blade-Control Switch (Power
Takeoff)
The blade-control switch (PTO) engages and
disengages power to the mower blades
The LCD indicator appears on the information screen
when the PTO switch is disengaged.
Note:
Machines equipped with the Horizon Display
Monitor have a clutch saver, which allows the throttle
to automatically reduce the engine speed when
you disengage the PTO switch. Engaging and
disengaging the PTO switch changes the engine
throttle between M
OW
Note:
The system allows you to start the machine
with the PTO switch engaged, but does not engage
the blades. Engaging the PTO requires you to reset
the PTO switch by disengaging, then engaging it.
Neutral-Lock Position
Use the N -
EUTRAL LOCK
safety-interlock system to engage and to determine
the N position.
EUTRAL
Key Switch
Use this switch to start the engine. It has 3 positions:
S , R , and O .
TART UN FF
Note:
The LCD indicators appear when each control
meets the "safe to start" mode (e.g., the indicator
turns on when you are in the seat.)
Note:
The engine ECU controls the glow plugs during
cold starts. If the coolant temperature is too low, the
glow symbol displays on the monitor and the starter
does not crank when you turn the engine to the S
position. The glow plugs activate in the O
position. Once the glow has been on long enough
for the current temperature, the glow symbol on the
monitor disappears and the engine cranks when
turned to the S position.
TART
Note:
The system allows you to start the machine the
with the PTO switch engaged, but does not engage
the blades. You must reset the PTO to engage the
PTO.
(Figure
and T mode.
RANSPORT
position with the
or S
N
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
5).
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.

Specifications

Overall Width—Side Discharge Machines
Without the deck
Deflector up
Deflector down
Overall Width—Rear Discharge Machines
60-inch Deck
168.2 cm (66.2 inches)
Overall Length—Side Discharge Machines
Roll bar up or down
Overall Length—Rear Discharge Machines
Roll bar up or down
Overall Height—All Machines
TART
Roll bar up
TART
Roll bar down
Overall Height—All Machines
Roll bar up
Roll bar down
Tread Width of Drive Wheels—All Machines
112 cm (44.1 inches)
15
60-inch Deck 72-inch Deck
141.2 cm (55.6 152.4 cm (60
inches) inches)
156 cm (61.4 186.4 cm (73.4
inches) inches)
184.9 cm (72.8 215.6 cm (84.9
inches) inches)
72-inch Deck
198.7 cm (78.2 inches)
60-inch Deck 72-inch Deck
244.9 cm (96.4 253 cm (99.6
inches) inches)
255.5 cm (100.6 inches)
182.4 cm (71.8 inches)
129.5 cm (51 inches)
182.4 cm (71.8 inches)
129.5 cm (51 inches)