Description For Fax Service Mode; Bit Switch - Canon JX500 Service Manual

5-12 Description for FAX Service Mode

5-12-1 #1 Bit Switch

SW01 Report Output Setting
BIT
0 Error code LCD indication/output (for serviceman)
1 Error memory dump (protocol damp)
2 No error report while pressing [
*3 Not used
*4 Not used
5 Activity report printout completion buzzer
6 Header setting (user switch over-ride)
7 V.34 activity report output
*[Bit 3] to [Bit 4]: Do not use the bits.
SW02
BIT
0 NL equalizer selection
1 Echo protection tone to V.29
*2 Reception sensibility setting (during TCF reception at V.17)
3 DIS bit33 or more transmission
4 DIS twice hearing
5 1st DIS inobservance
6 Frequency for unobserving the 1st DIS
7 1,080 Hz output before CED
*[Bit 2]: For prohibiting lower RX transmission level after the TCF reception.
SW03 Echo countermeasure setting
BIT
0 Carrier break detection between DCS and TCF
*1 Carrier break waiting time between DCS and TCF
2 End flag during V.21 signal transmission
*3 Not used
*4 Not used
*5 Not used
6 CNG during the manual transmission
7 CED during the manual reception
*[Bit 1]: For outputting the error memory dump.
*[Bit 3] to [Bit 5]: Do not use the bits.
FUNCTION
Stop] key.
FUNCTION
FUNCTION
Part 1 - 60
1
Available Not available
Available Not available
Not available Available
Available Not available
Not available Available
Available Not available
1
Available Not available
Available Not available
Not available Available
Not available Available
Available Not available
Available Not available
1,650 Hz 1,850 Hz
Available Not available
1
Not available Available
600 ms
2
Not available Available
Not available Available
0
0
0
300 ms
1