Siemens SINUMERIK 828D PPU Series Manual page 231

Note
Tools for configuring and analyzing PROFINET components
To configure and analyze PROFINET components, Siemens Automation and Drives Service
& Support provides the following tools at no cost:
● Primary Setup Tool (PST)
● PRONETA
Configuration
The device name must be defined in the following cases:
● When commissioning for the first time
● When a device is replaced
The PC must be connected using a crossover cable with, e.g. X2 at the PN/PN coupler.
Procedure:
1. Under "Tools" select → "Set PG/PC interface" →"TCP/IP" → "Intel(R) PRO/100 VM".
2. Under "Target system" select → "Edit Ethernet nodes ...".
3. In the dialog window "Edit Ethernet Nodes", press the "Search..." button under "Nodes that
4. In the dialog window "Search Network" select the coupler and press "OK".
PPU
Manual, 01/2014, 6FC5397-2DP40-3BA3
Using the Primary Setup Tool (PST), you can configure PROFINET components, e.g. you
can allocate the PN/PN coupler a device name.
You can find this tool in the Internet at the following address:
support.automation.siemens.com/WW/view/en/19440762)
PRONETA (PROFINET network analysis) is a PC tool to analyze PROFINET networks.
You can find this tool in the Internet under the following address:
support.automation.siemens.com/WW/view/en/67460624)
can be accessed online".
Spare parts and accessories
9.2 PN/PN coupler
(http://
(http://
231