Siemens SINUMERIK 828D PPU Series Manual page 145

Table 7-52
Parameter
Voltage:
Typical load current (without external
series resistor):
Switch S1, S2
Table 7-53
1
OFF
The two switches S1-9 and S1-10 must remain set to "ON".
The switches S1-1 to S1-8 define the PROFINET address. For a SINUMERIK 828D, the address "64"
must always be assigned to the MCP.
Table 7-54
1
OFF
The handwheel signal type is set with switch S2-1.
Table 7-55
Note
Switch S2-2 is reserved for test purposes.
PPU
Manual, 01/2014, 6FC5397-2DP40-3BA3
Technical data of the outputs of X111 to X114
Setting of switch S1 as delivered
2 3 4
OFF OFF OFF
Switch S1 settings
2 3 4
OFF OFF OFF
Switch S2 settings
1 Meaning
ON differential interface
OFF TTL interface
Value
0 V to 5 V (depending on the load)
8 mA at LED flow voltage = 2.3 V
15 mA at short-circuit
5 6 7 8
OFF OFF OFF OFF
5 6 7 8
ON
OFF OFF OFF
Connectable components
7.3 MCP Interface PN
9 10 Meaning
ON ON PLC I/O Interface
PROFINET address "0"
9 10 Meaning
ON ON
PROFINET address "64"
145