Siemens SINUMERIK 828D PPU Series Manual page 182

Connectable components
7.6 PP 72/48D PN
Note
The "alive and well" counter is a 3 bit modulo counter on a PP application level. The PP
application can be monitored using this counter. Failure of the application software does not
generally result in a communication failure, as this is developed in a hardware-supported
manner. The watch dog switches off the digital outputs, while the inputs remain at their last
set values.
Table 7-77
"alive and
well" counter
0
1
2
3 ... 7
Table 7-78 Elimination of error at "alive and well" counter status "2"
Value Cause
byte 1
1 In the temperature
measurement operating
mode, an input voltage is too
high. The hardware may
become damaged/
destroyed as a result.
2 Reserved
3 Overload at the outputs
4 Incorrect operating mode
selection, e.g. temperature
measurement at the analog
outputs.
5 Internal error, system error
182
Overview of messages as a function of the "alive and well" counter
Value Message
byte 1
0 Reserved
Temperature value
0 No error
1 Impermissible input voltage in temperature measurement mode
2 Reserved
3 Overload at the outputs
4 Incorrect operating mode selection
5 Internal error, system error
6 Overrange at the inputs
7 Overrange at the outputs
0 Reserved
Effect
The "PNFault" LED is activated.
The outputs are disabled.
The value 0x80 is stored in Status Byte
1.
-
The "PNFault" LED is activated.
The outputs are disabled.
The value 0x80 is stored in Status Byte
1.
Selection of operating mode is rejected,
The "PNFault" LED is activated.
The outputs are disabled.
The value 0x80 is stored in Status Byte
1.
Remedy
It is essential that a Pt100 element is
connected to terminals 3-4 or 7-8.
1)
The module must be restarted with
Power ON following elimination of the
error.
-
Check the loads at the analog output.
The module must be restarted with
1)
Power ON following elimination of the
error.
If selected correctly, the module switches
to cyclic operation.
The firmware has detected a system
error, this status can only be exited by
1)
means of a switch-on / switch-off.
Manual, 01/2014, 6FC5397-2DP40-3BA3
PPU