Siemens SINUMERIK 828D PPU Series Manual page 103

X60 handwheel
Via X60, you can connect 1 handwheel either with TTL or difference signals.
Note
The handwheel is supplied by the MCP module with 5 V / 100 mA. An external power supply
is not permitted.
NOTICE
Handwheel connections
The SINUMERIK 828D software can process up to three handwheels. You can connect two
handwheels to the PPU. You can connect an additional handwheel to the machine control
panel.
Connector designation:
Connector type:
Table 7-8
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Switch S1
The handwheel signal type is set with switch S1.
Closed
Open
Switch S1 is closed when supplied ex works.
PPU
Manual, 01/2014, 6FC5397-2DP40-3BA3
X60
15-pin Sub-D socket
Assignment of connector X60
Name
P5V
M
HW1_A
HW1_XA
N.C.
HW1_B
HW1_XB
N.C.
P5V
N.C.
M
N.C.
N.C.
N.C.
N.C.
differential interface
TTL interface
Type Meaning
V 5 V power supply
V Ground
I Handwheel pulses track A
I Handwheel pulses track A (negated)
- Not assigned
I Handwheel pulses track B
I Handwheel pulses track B (negated)
- Not assigned
V 5 V power supply
- Handwheel 2 pulses track A (negated)
V Ground
- Not assigned
- Not assigned
- Not assigned
- Not assigned
Connectable components
7.1 MCP 483C PN
103