Using The Magnify Feature - Dukane 8980WUSS User Manual

Operating

Using the magnify feature

1.
Press the MAGNIFY ON button on the remote
control.
The picture is magnified, and the MAGNIFY dialog
appears on the screen. When the MAGNIFY ON
button is pressed for the first time after the projector
is turned on, the picture is zoomed by 1.5 times. On
the dialog, triangle marks to show each direction are
displayed.
2.
The display magnification of the projector switches with every
press of the MAGNIFY ON button.
For computer signals, RGB signals for HDMI
DisplayPort
1.5 times
For video signals, Component signals for HDMI
DisplayPort
1.5 times
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnification.
NOTE
• The MAGNIFY dialog automatically disappears in several seconds
with no operation. The dialog appears again if the MAGNIFY ON button is
pressed when the dialog has automatically disappeared.
• The magnification is automatically disabled when the displaying signal or its
display condition is changed.
• While the magnification is active, the keystone distortion condition may vary. It
is restored when the magnification is disabled.
• Some horizontal stripes might be visible on the image while magnification is
active.
• This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
, input signals from the LAN port
TM
2 times 3 times
, SDI signals
TM
2 times 1 time
TM
4 times 1 time
48
MAGNIFY
ON / OFF
button
NETWORK INTERACTIVE
INFO
, HDBaseT and
TM
, HDBaseT
TM TM
and
QM00481-1