Using The Remote Id Function; Changing The Frequency Of Remote Control Signal - Dukane 8980WUSS User Manual

Using the REMOTE ID function

Use this function to control specific projectors by the remote
control assigned the same ID number when you use multiple
projectors of the same type at the same time.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION
99). Press the ID button with the same ID number
menu (
as assigned to the projector you are going to control. The ID
button selected lights for several seconds.
NOTE
• Each time you press any button (except ID buttons), the ID button of
current selected ID number lights.
• To confirm the projector's current ID, press any ID button for three seconds.
Its number is shown on each screen regardless of set ID of projector.

Changing the frequency of remote control signal

The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
To set the Mode, press the combination of two buttons listed below simultaneously
for about three seconds.
(1) Set to Mode 1:NORMAL
MENU and MY BUTTON-4 buttons
(2) Set to Mode 2:HIGH
RESET and MY BUTTON-1 buttons
The REMOTE FREQ. in the SERVICE
item of the OPTION menu (
the same mode as the remote control.
99) of the projector to be controlled should be set to
29
(2)
RESET
button
MY
NETWORK INTERACTIVE
BUTTON-1
INFO
button
Remote control
ID buttons
NETWORK INTERACTIVE
INFO
(1)
MENU
button
MY
BUTTON-4
button
QM00481-1