7.
The ceiling mount skirt does not have legs. The base has rear flanges that will not
allow it to sit level. Use wood to assist in keeping the flanges/skirts raised, and keep the
assembly level for the remainder of the installation.
8.
The ceiling mount hood is now ready to be placed on the top of the skirt. Place the
skirt at the final location desired, and in accordance with all clearance requirements. Apply a
bead of silicon along the top of the panels.
CAUTION
9.
Final installation is to be determined by contractor and structural engineer. The
ceiling structure and mounting must be structurally capable to support the hoods weight and
mounting system.
Use ½" diameter threaded rods to hang ceiling mounted hoods. The holes in the
ceiling and structure shall be 9/16" diameter. The following figure is the hole locations to
hang a WVU-48 hood.
16