Wells GK48 Owner's Manual page 12

1.1 INSTALLING AND ASSEMBLING BASE MOUNTED HOOD
A base mounted hood will need to have the base assembled in place prior to raising the
hood and installing it on to the base.
1. Uncrate the hood and all components.
2. Assemble the base in the location that the hood will be located.
3. Locate the required hardware to assemble the base. The hardware required includes
1/4-20 UNC x .75 long Hex Head Cap Screws (bolt), 1/4 Flat Washers, and 1/4-20 UNC
Hex Nuts.
4. Use a flat, smooth, and clean floor surface, with all debris or obsturctions removed
to avoid damage. Align the two rear panels and secure to each other with one bolt, flat
washer, and nut at each hole location (8 places).
REAR PANEL - 2 REQUIRED
(NOTE. NUMBER 4 FOR BOTH
PANELS ARE ALIGNED).
SK2963
1/4-20 UNC X .750 HEX HEAD CAP SCREW
WITH FLAT WASHER UNDER HEAD
(8 PLACES)
10
1/4-20 UNC HEX NUT
(8 PLACES)
SK2964