•
The next step places the hood on to the base assembly. The hood needs to be supported
by a supporting device that is acceptable to raise the hood into position.
9. Install the hood directly downward on to the base assembly, ensure the silicon makes an
airtight seal. Secure with the bolt, flat washer, and nut at each hole location.
HOOD. NOTE, THE
SIDE PANELS ARE
NOT INSTALLED. THESE WILL
BE INSTALLED LATER.
ASSEMBLY FROM
PREVIOUS STEP
The unit is now complete and ready for electrical installation, fire extinguishing system
assembly, equipment installation, and final assembly.
INSIDE BASE DEFLECTORS
CAN BE INSTALLED AT
ANY TIME. SEE SECTION ON
INSTALLATION.
CAUTION
1/4 FLAT WASHER
(22 PLACES)
1/4 X 20 UNC HEX NUT
(22 PLACES)
13
1/4-20 X .750 HEX HEAD CAPSCREW
(22 PLACES)
INSTALL SIDE PANELS
AT END OF INSTALLATION.
BOTH SIDES.