Drive Belt Replacement - 3M -Matic AccuGlide 3 200a Instructions And Parts List

13-MAINTENANCE AND REPAIRS (continued)
• To reduce the risk associated with mechanical and electrical hazards:
- Turn electrical supply off and disconnect before performing any adjustments, maintenance or
servicing the machine or taping heads.
13.8 Box Drive Belt Replacement
Note – 3M recommends the replacement of drive
belts in pairs, especially if belts are unevenly worn.
Lower Drive Belts (Figure 13-4)
1. Remove and retain center plate (A) and four (4)
screws.
2. Remove and retain side cover (B) and fasteners.
3. Loosen, but do not remove lock nut (C).
4. Loosen tension screw (D) until all belt tension is
removed.
5. Pull belt splicing pin (E) out and remove belt.
6. Place new belt over pulleys with laced splice at
top. Insert splicing pin.
Important – Pin must not extend beyond edge of belt.
7. Adjust belt tension as explained in "Adjustments
- Box Drive Belt Tension."
8. Replace side cover and center plate and secure
with original fasteners.
200a-NA
WARNING
E
B
Figure 13-4 Lower Drive Belt Replacement
30
A
D
C
Figure 13-5
Upper Drive Belt
Replacement
2009 February