Drive Belt Replacement - 3M -Matic 7000r-I Instructions And Parts List

13. Maintenance and Repairs
13.8 Box Drive Belt Replacement
explained
Upper Drive Belts - Figure 13-2
explained
3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 43
44-0009-2165-8 / ECO# 0078045
Note – 3M recommends replace-
ment of drive belts in pairs,
especially if belts are
unevenly worn.
Lower Drive Belts - Figure 13-1
1. Remove and retain center
plate (A) and four (4) screws.
2. Remove and retain side cover (B)
and fasteners.
3. Loosen, but do not remove lock
nut (C).
4. Loosen tension screw (D) until all
belt tension is removed.
5. Pull belt splicing pin (E) out and
remove belt.
6. Place new belt over pulleys
with laced splice at top.
Insert splicing pin.
Note – Pin must not extend beyond
edge of belt.
7. Adjust belt tension as
in "Adjustments – Box Drive Belt
Tension".
8. Replace side cover and center
plates and secure with original
fasteners.
1. Remove and retain center
plate (A) and four (4) screws and
plain washers.
2. Loosen, but do not remove lock
nut (B).
3. Loosen tension screw (C) until all
tension is removed from belt.
4. Remove four (4) screws on side
of belt guard (D) and slide belt
guard out to expose belt.
5. Pull belt splicing pin (E) out and
remove belt.
6. Place new belt over pulleys
with laced splice at top.
Insert splicing pin.
Note – Pin must not extend beyond
edge of belt.
7. Adjust belt tension as
in "Adjustments – Box Drive Belt
Tension".
8. Replace front cover and belt
(continued)
B
E
Figure 13-1 Lower Drive Belt Replacement
Figure 13-2 Upper Drive Belt Replacement
Original Instructions
Source Document for all related Manuals/Translations
C A
D
A
B
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
- Turn peumatic and electrical supplies off
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
E
D
C
International - ENG
February 2021