ZyXEL Communications VMG4005-B50B User Manual page 12

Figure 5 Distance Between Holes
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
3
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the VMG with the connection
4
cables.
Align the holes on the back of the VMG with the screws on the wall. Hang the VMG on the screws.
5
Figure 6 Wall Mounting Example
Chapter 1 VMG Introduction
VMG4005-B50B User's Guide
12