System Settings; Network; Ip Settings - EverFocus EDN288MS User Manual

7.1. System Settings

7.1.1. Network

You can configure network-related settings, including IP, Multicast, DHCP, DDNS and Port on this
page. Click the tab of the one you want to see.

7.1.1.1. IP Settings

Enter the IPv4 details in this area, which applies to your system.
IPV4: Click the radio to enable IPv4 (Internet Protocol version 4), and then enter the IPv4 details
in this area.
Static IP: Click the radio to enable Static IP. You can manually set the Static IP address. This type of
address is stable and cannot change, but the user has to make sure there are no address conflicts
with other network-connected devices.
DHCP: Click the radio to enable DHCP. This setting lets the system use an automatically assigned
(dynamic) IP address. This address can change under certain circumstances, such as when the
camera's network switch / hub has to be rebooted. Do not assign to the DHCP server the same IP
addresses used for the other network cameras and PCs with unique IP addresses.
IP Address: When DHCP is not used, the user needs to manually enter the IP address of the
camera. Do not enter an IP address that is already used for your computer or other network
cameras.
Stainless Steel 2MP/3MP/4MP Network Cameras
26