Table of Contents
Advertisement
CONNECTIONS
3.5mm jack steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel.
For the radios listed below: Connect the female 3.5mm connector with stripped leads, to the
•
male 3.5mm SWC jack from the 7388 harness. Any remaining wires tape off and disregard:
•
Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire from the connector. Then connect the remaining steering wheel control wire, normally
Brown/White, to the Brown wire from the connector .
•
Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
•
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire to
the Brown wire.
Note: If the Kenwood radio auto detects as a JVC, manually set the radio type to Kenwood.
See the instructions under Changing Radio Type.
•
XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
•
Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must have rev. 2.1.4 or higher software.
•
Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as Key-A
or SWC-1, to the Brown wire from the connector. Then connect the remaining steering wheel
control wire, referred to as Key-B or SWC-2, to the Brown/White wire from the connector. If
the radio comes with a third wire for ground, disregard this wire
has been programmed to the vehicle, refer to the manual provided with the radio for
assigning the SWC buttons. Contact the radio manufacturer for more information .
•
For all other radios: Connect the 3.5mm jack from the 7388 harness into the jack from the
aftermarket radio designated for an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt as to where the 3.5mm jack should connect to.
6
(CONT.)
. Note: After the interface
INSTALLING THE AXXESS INTERFACE
AND AX-HYKIA-SPDIF
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the 7388 harness, into the
Axxess interface.
2. Connect the 7388 harness to the AX-HYKIA-SPDIF interface.
3. Connect the 7388 harness to the climate display.
4. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
Attention! If retaining steering wheel controls, ensure that the SWC jack/wire is connected to the
radio before proceeding. If this step is skipped, the interface will need to be reset for the steering
wheel controls to function.
|
1.800.221.0932
MetraOnline.com
Advertisement
Table of Contents
