Table of Contents
Advertisement
Dual assignment instructions (long button press)
The Axxess interface has the capability to assign (2) functions to a single button, except Volume
Up and Volume Down. Follow the steps below to program the button(s) to the desired setting.
Note: Seek Up and Seek Down come pre-programmed as Preset Up and Preset Down for a long
button press.
1. Turn the key to ignition but do not start the vehicle.
2. Press and hold the desired steering wheel control button for (10) seconds, or until the L.E.D.
flashes rapidly. At this point release the button; the L.E.D. will then go solid.
3. Press and release the Volume Up button the number of times corresponding to the new
button number selected. Refer to the Dual Assignment Legend. The L.E.D. will flash rapidly
while the Volume Up button is being pressed, and then go back to a solid L.E.D. once
released. Proceed to the next step once the Volume Up button has been pressed the desired
number of times.
Caution: If more than (10) seconds elapses between pressing the Volume Up button, this
procedure will abort, and the L.E.D. will go out.
4. Press the desired button to store it to memory. The L.E.D. will now go out indicating the new
information has been stored to memory.
Note: These steps must be repeated for each button desired to assign a dual assignment feature
to. To reset a button back to its default state, repeat Step 1, then press the Volume Down button.
The L.E.D. will go out, and the dual assignment feature for that button will be erased.
STEERING WHEEL CONTROL SETTINGS
(CONT.)
Dual Assignment legend
1. Not allowed
7. Preset-Up
2. Not allowed
8. Preset-Down
3. Seek-Up/Next
9. Power
4. Seek-Down/Prev
10. Band
5. Mode/Source
11. Play/Enter
6. ATT/Mute
12. PTT (Push to Talk)
* Not applicable in this application
TROUBLESHOOTING
Resetting the Axxess interface
1. The Blue reset button is located inside the Axxess interface, between the two connectors.
The button is accessible outside the Axxess interface, no need to open the Axxess interface.
2. Press and hold the reset button for (2) seconds, then let go to reset the Axxess interface.
3. Refer to Programming the Axxess Interface from this point.
13. On-Hook
14. Off-Hook
15. Fan-Up *
16. Fan-Down *
17. Temp-Up *
18. Temp-Down *
REV. 11/19/2018 INST99-7388HG
11
Advertisement
Table of Contents
