Table of Contents
Advertisement
Changing radio type
If the L.E.D. flashes do not match the radio you have connected, you must manually program the
Axxess interface to tell it what radio it is connected to.
1. After (3) seconds of turning the key on, press and hold the Volume Down button on the
steering wheel until the L.E.D. in the Axxess interface goes solid.
2. Release the Volume Down button; the L.E.D. will go out indicating the Axxess interface is in
Changing Radio Type mode.
3. Refer to the Radio Legend to know which radio number you would like to have programmed.
4. Press and hold the Volume Up button until the L.E.D. goes solid, and then release. Repeat
this step for the desired radio number you have selected.
5. Once the desired radio number has been selected, press and hold the Volume Down
button on the steering wheel until the L.E.D. goes solid. The L.E.D. will remain on for about
(3) seconds while it stores the new radio information.
6. Once the L.E.D. goes out, the Changing Radio Type mode will then end. You can now test
the steering control wheel controls.
Note: If at any time the user fails to press any button for a period longer than (10) seconds, this
process will abort.
STEERING WHEEL CONTROL SETTINGS
(CONT.)
Radio legend
1 flash - Eclipse (Type 1) †
7 flashes - Alpine *
2 flashes - Kenwood ‡
8 flashes - Visteon
3 flashes - Clarion (Type 1) †
9 flashes - Valor
4 flashes - Sony/Dual
10 flashes - Clarion (Type 2) †
5 flashes - JVC
11 flashes - Metra OE
6 flashes - Pioneer/Jensen
12 flashes - Eclipse (Type 2) †
Continued on the next page
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBA
18 flashes – JBL
REV. 11/19/2018 INST99-7388HG
9
Advertisement
Table of Contents
