Double Din/Stacked Iso Din Head Unit Provision; Axxess Interface Installation - Metra Electronics 99-3010S Installation Instructions Manual

Kit Assembly
Double DIN/Stacked ISO DIN
head unit provision
1. Cut and remove the center support
(For DDIN only). (Figure A)
2. Snap the Double DIN brackets to
the inside edge of the Double DIN
radio housing. (Figure B)
3. Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly
and secure the Double DIN head
unit or stacked ISO head units to
the assembly using the screws
supplied with the radio. (Figure C)
4. Snap the double DIN trim plate into
the DDIN radio housing. (Figure C)
5. Reassemble dash in reverse
order of disassembly using the
99-3010S radio trim panel instead
of the factory panel.
6. Programming: You must cycle the
A/C fan speed all the way to high
and back to low when you first
install the kit.
(Figure A)
(Figure B)
(Figure C)
99-3010S
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power)
• Used in amplified or non-amplified systems
• Retains all warning chimes
• Provides NAV outputs (parking brake, reverse, mute, and V.S.S.)
• Retains OnStar/OE Bluetooth
• Adjustable volume for chimes and OnStar
• High level speaker input
• Micro "B" USB updatable
• Retains balance and fade
• 4-pin to 4-pin resistor pad harness • 16-pin with stripped leads • 22-pin to 44-pin
Camaro Harness • 18-pin to 10-pin HVAC Harness
• Cutting tool • Crimping tool • Tape • Connectors (butt-connectors, bell caps, etc.)
5
Axxess Interface
Installation
FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED