Advertisement
Saddle Tramp WR Box Assembly 1
1. Unsnap the Cap from the case. Insert the
overmolded gaskets from the BC-9715
harness into the respective opening in
the front of the Cap, making sure the
grommets are properly seated.
2. Slide the DSP board out of the case and
plug in the 16 and 20 pin connectors.
3. Reinsert the DSP board into the case and
snap the Cap into place. The arrows on
the Cap should be pointed toward the
Saddle Tramp logo on the case.
4. Find a secure mounting location for
the DSP case. It is recommended that
the cap be installed facing down. The
Zip-tie Mounts on each side of the case
can be used to secure the DSP into place.
6
BC-DSPX-HD2 INTERFACE ASSEMBLY
Case
Saddle Tramp DSP
Circuit Board
Cap (with O-ring)
16-Pin
Gasket
BC-9715
Harness
Zip-tie Mounts
20-Pin
|
386.257.1187
MetraOnline.com
Advertisement
