Installing The Interface - Metra Electronics 99-5834CH Installation Instructions Manual

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
Touchscreen display
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the 5834 harness to the wiring harnesses in the vehicle. These harnesses are
the ones removed in step 7 of dash disassembly. Then insert the 5834 harness into port
"A" in the touchscreen display. But do not install this harness until exactly before step 1
of "Initializing the Interface". This is a timed process.
3. Connect the 4-pin harness with yellow RCA jacks into port "C" in the
touchscreen display.
4. Disregard ports "D" and "E", they will not be used in this application.
5. Port "F" is an update port for future firmware upgrades.
A
F

INSTALLING THE INTERFACE

B
C
D
E
HVAC interface
6. Connect the HVAC interface harness into the HVAC interface, and then to the
wiring harnesses in the vehicle. These harnesses are the ones removed in step 4
of dash disassembly.
Note: Disregard the 10-pin harness, it will not be used in this application.
7. Connect the 4-pin flat to 4-pin stacked harness into the HVAC interface, and then to
the passenger airbag light assembly.
8. Connect the male DIN connector with a 6-pin harness, to the female DIN jack from the
5834 harness. It would be best to tape or heat shrink this connector to prevent it from
being disconnected.
a. Then connect the 6-pin harness into the HVAC interface.
b. Disregard the Red wire, it will not be used in this application.
9. (a) For models with a 4.2-inch display screen: Connect the 12-pin backup camera
harness, to the wiring harness in the vehicle. This harness is the one removed in step 5
of dash disassembly.
(b) For models with an 8-inch display screen: Connect the female connector of the
54-pin backup camera harness, to the wiring harness in the vehicle. This connector is
located behind the factory display screen, which was removed in step 5 of
dash disassembly.
Note: Disregard the male connector, it will not be used in this application.
10. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Metra recommends using the proper mating adapter from Metra.
9