Rebooting Your Switch - HP 12500 Series Installation Manual

1/18
Table 17 Command output
Field
Slot No.
Brd Type
Brd Status
Software Version

Rebooting your switch

CAUTION:
Rebooting the switch interrupts network services.
To avoid configuration loss, use the save command to save the running configuration before a reboot.
Before a reboot, use the display startup and display boot-loader commands to verify whether you have
specified the correct startup configuration file and startup software images.
You can reboot the switch in one of the following ways:
Power off and then power on the switch. This method might cause data loss, and is the
•
least-preferred method.
Immediately reboot the switch at the CLI.
• Schedule a reboot at the CLI, so the switch automatically reboots at the specified time or after the
specified period of time.
LST1SF08B1 Normal
Description
•
In standalone mode:
Slot No.—Slot number of a card.
•
In IRF mode:
Slot No.—Slot number of a card on the specified member switch in the format of
member ID/slot number.
Hardware type of a card, which can be:
•
Specific card model—Type of a card (such as LST2MRPNC1), which is the same as
the silkscreen.
•
NONE—No card is in the slot.
•
UNKNOWN—The card is not supported by the software version and thus cannot
start properly.
Card status, which can be:
•
Absent—No card is in the slot.
•
Master—The card is an active main processing unit (MPU).
•
Standby—The card is a standby MPU.
•
Normal—The card is operating properly.
•
Fault—The card in the slot has not started up or has failed.
•
Off—The card is not powered on.
•
Illegal—The card is not supported by the software version and thus cannot start
properly.
Software version of the current card, which can be:
•
Specific software version.
•
NONE—No card is in the slot.
•
Mismatched—The software version does not support the card and thus cannot be
uploaded.
12500-CMW710-R7128
62