Powering On The Switch - HP 12500 Series Installation Manual

Powering on the switch

IMPORTANT:
Before powering on the switch, identify the power switch in the equipment room so that you can disconnect
the power supply promptly in case of an emergency.
Before powering on the switch, verify that:
The interface cables, power cords, and the grounding cable are correctly connected.
•
The input power voltage meets the requirement of the switch.
•
• The console cable is properly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
Powering on the switch
Turn on the power switch of the power source providing power to the switch.
1.
Turn on the power switch on the switch.
2.
Before the switch is powered on, the basic manufacturing information about the switch is displayed:
DDR2 SDRAM test successful.
System is starting...
Booting Normal Extend BootWare
The Extend BootWare is self-decompressing
Done!
**************************************************************************
*
*
*
**************************************************************************
Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
Compiled Date
CPU Type
CPU L1 Cache
CPU L2 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
cfa0 Size
NVRAM Size
BASIC CPLD Version
EXTEND CPLD Version : 004
PCB Version
The switch initiates the power-on self-test (POST) and the results are displayed at the console terminal.
Board self testing...........................
Board steady testing...
HP 12500 BootWare, Version 2.17
: Sep 15 2012
: MPC8548E
: 32KB
: 512KB
: 1000MHz
: DDR2 SDRAM
: 4096MB
: 400MHz
: 4MB
: 128MB
: 999MB
: 1024KB
: 004
: Ver.B
54
[ PASS ]
*
*
*