Charging The Optional Battery Pack With The Optional Battery Charger - SATO TH2 Series Operator's Manual

Section 2: Installation
2.4 CONNECTIONS (cont'd)

2.4.6 Charging the optional battery pack with the optional battery charger

Caution
The optional battery pack and battery charger purchased for this printer are specific to this printer only.
Do not use them for other electrical devices.
1.
Connect the DC power plug of the AC adapter to the
charger unit. Then, connect the AC power cable to the
AC adapter and plug the other end of the cable to the AC
outlet.
2.
Insert the battery pack into the slot, with the terminal
pointing downward.
When charging begins, the CHARGE lamp (red) lights.
When charging is complete, the CHARGE lamp lights
green (fully charged).
3.
Remove the battery pack when charging is complete.
Charging time
It takes about 1.5 hours for the CHARGE lamp to turn
green when charging a completely depleted battery.
Notes:
• When the CHARGE lamp is not lit, check that the battery
pack is installed securely.
The battery may not be charged when not securely
installed.
• When a charged battery pack is installed, the CHARGE
lamp first lights red, then lights green.
Page 2-10 TH2 Series Operator Manual