Installing Optional Memory Storage; Installing The Optional Sd Card; Removing The Optional Sd Card - SATO S84 Operator's Manual

2 Installing the Printer

2.8 Installing Optional Memory Storage

The optional SD card or USB memory can be used for uploading and downloading data (print format,
graphics, extended characters) registered in the printer and printer firmware.
Contact your SATO reseller or service center for the recommended SD card or USB memory.
2.8.1

Installing the Optional SD Card

You can install an optional SD card into the SD card slot located on the rear of the printer.
When using the SD card for the first time, format the SD card in the memory card mode. Refer to
Section 4.2.11 Memory Mode
1
Power off the printer.
2
Insert the optional SD card into the SD
card slot with the orientation the same
as shown in the picture.
Contact your SATO reseller for the recommended
SD card.
3
To seat the SD card in the SD card slot,
push it in until it makes a slight clicking
sound and is almost completely inside the
printer.
When seated and ready to operate, only a very
small portion protrudes, approximately 3.18 mm
(0.125").
2.8.2

Removing the Optional SD Card

1
Power off the printer.
2
Press the card edge slightly to release the
SD card from the SD card slot. The SD
card slot will immediately release the SD
card .
CAUTION
Do not remove the SD card while the printer is accessing the data in the SD card. Doing so may result in data
corruption.
34
S84-ex/S86-ex Operator Manual
for details.
1
2
1