Optional Lighting - Toro Reelmaster 6700-D Operator's Manual

Optional Lighting

Important If optional lighting is be added to the traction unit, use the instructions, schematic and part numbers listed
below to prevent damage to the traction units electrical system.
Installation Instructions
Install a relay into the open connector under console.
Install light switch.
Note: Punch out in control panel provided for switch
installation.
Crimp a ring or fork terminal onto each of the orange
wires (J 24 & J 25) under console. Secure them to light
switch terminals #2 & #3.
FUSE 10 A
P/N: 218–578
IGNITION SW.
FUSE 7.5 A
B A
ENGINE GROUND
Switch
Toro Part No. 75-1010
Honeywell Part No. 1TL1-2 Hella Part No. 87411 B
J24
2
ORANGE
SWITCH
P/N: 75–1010
(IN EXISTING TRACTOR HARNESS)
Figure 70
Relay
Toro Part No. 70-1480
Splice power (+) wires from lights to red wire at J 23.
Secure ground wires from lights to the engine block
ground.
Install a 10 amp. fuse to fuse block at location shown on
fuse block decal. Do not exceed fuse rating.
30
RED
J25
3
85
ORANGE
RELAY
P/N: 70–1480
BLACK
45
87a
87
RED
86
J23
LIGHTS