Fuses; Optional Lighting - Toro 03806 Operator's Manual

of baking soda and water. Rinse with clear water. Coat
the battery posts and cable connectors with Grafo 112X
(skin-over) grease (Toro Part No. 505-47) or petroleum
jelly to prevent corrosion.
DANGER
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.

Fuses

There are 7 fuses in the machines electrical system.
They are located below the operators control panel
(Figure 60 and Figure 61).
1. Fuses
1
Figure 60
Figure 61

Optional Lighting

Important: If optional lighting is be added to
the traction unit, use the instructions, schematic
(Figure 62), and part numbers listed below to
prevent damage to the traction units electrical
system.
Installation Instructions
1. Install a relay into the open connector under console.
2. Install light switch.
Note: Punch out in control panel provided for
switch installation.
3. Crimp a ring or fork terminal onto each of the
orange wires (J 24 & J 25) under console. Secure
them to light switch terminals #2 & #3.
4. Splice power (+) wires from lights to red wire at J 23.
5. Secure ground wires from lights to the engine block
ground.
6. Install a 10 amp. fuse to fuse block at location shown
on fuse block decal. Do not exceed fuse rating.
G019475
44