Toro Reelmaster 6700-D Operator's Manual page 13

2. Remove protective plugs from each end of cutting unit.
3. Lubricate and install a large O-ring into bearing housing
groove on each end of cutting unit (Fig. 3 & 6).
3
2
Figure 3
1. Bearing housing
2. Large o-ring
Note: Before installing cutting unit motors or
counterweights, lubricate internal splines of cutting unit
reel shafts with grease.
4. Install a counter weight onto appropriate end of each
cutting unit with capscrews provided (Fig. 3).
5. Thoroughly grease the cutting unit reel bearings prior to
installation on the traction unit. Grease should be
evident at the inboard reel seals; refer to Cutting Unit
Operator's Manual for greasing procedure.
6. Insert a thrust washer onto horizontal shaft of pivot
knuckle as shown in Figure 4.
5
3
2
4
Figure 4
1. Carrier frame
2. Pivot knuckle
3. Lift arm steering plate
7. Insert the horizontal shaft of the pivot knuckle into the
mounting tube of the carrier frame (Fig. 4).
1
3. Counterweight
1
4. Lynch pin
5. Steering locking pin
13
8. Secure pivot knuckle to carrier frame with a thrust
washer, flat washer and a flange head capscrew (Fig. 4).
9. Insert a thrust washer onto vertical shaft of pivot
knuckle (Fig. 4).
10. If removed, insert the vertical shaft of the pivot knuckle
into lift arm pivot hub (Fig. 4). Guide the pivot knuckle
in place between the two rubber centering bumpers in
the under side of the lift arm steering plate.
11. Insert the lynch pin into the cross hole on the pivot
knuckle shaft (Fig. 4).
12. Remove nut securing turf compensation spring
mounting bracket to cutting unit stabilizer ear (Fig. 5).
Insert tipper chain onto capscrew and secure with nut
removed.
Figure 5
1. Lift chain
13. Mount the motor to the drive end of the cutting unit and
secure with two capscrews provided (Fig. 6).
1
Figure 6
1. Motor
Note: If fixed cutting unit position is required, insert
steering locking pin into pivot knuckle mounting hole
(Fig. 4).
14. Hook spring wire around bottom of steering locking pin
(Fig. 4).
1
2
2. Cutting unit stabilizer ear
2
2. O-ring