Before Operating; Checking The Engine Oil; Checking The Cooling System - Toro Reelmaster 6700-D Operator's Manual

Before Operating

Note: Determine the left and right sides of the machine
from the normal operating position.

Checking the Engine Oil

Crankcase capacity is 7.5 qt. (7 L) with filter.
1. Park machine on a level surface. Release hood latch and
open hood (Fig. 12).
1
Figure 12
1. Hood latch
2. Remove dipstick (Fig. 13), wipe clean and reinstall
dipstick. Pull it out again and check oil level on
dipstick: Oil level should be up to FULL mark on
dipstick.
Figure 13
1. Dipstick
3. If oil level is low, remove filler cap and add SAE
10W30 CD, CE, CF, CF-4 or CG-4 oil until level
reaches FULL mark on dipstick. Do not overfill.
1. Filler cap
4. Install filler cap.
5. Close hood and secure latch.

Checking the Cooling System

Clean debris off screen, oil cooler and front of radiator
daily, more often if conditions are extremely dusty and
dirty; refer to section on Engine Cooling System.
The cooling system is filled with a 50 / 50 solution of water
and permanent ethylene glycol anti–freeze. Check level of
coolant in radiator and expansion tank at the beginning of
each day before starting the engine. Capacity of cooling
system is 10 quarts (9.4 l).
1
If the engine has been running, pressurized hot
coolant can escape and cause burns if the radiator
cap is removed.
Allow the engine to cool at least 15 minutes or until
the radiator cap is cool enough to touch without
burning hands.
1. Carefully remove radiator cap and expansion tank cap.
2. Check level of coolant in radiator and in expansion
tank. Radiator should be filled to the top of the filler
neck and the expansion tank filled to the FULL mark.
17
1
Figure 14
Caution