Setup; Installing The Cutting Units - Toro Reelmaster 6700-D Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total set-up cannot be completed. Some parts may have already been assembled at the factory.
Description
Counterweight
Large o-ring
Lynch pin
Steering locking pin
Diagnostic ACE display overlay
Key
Key ring
Gauge bar
Screw
Wing nut
EEC decals
EEC certificate
Operator's manual (traction unit)
Parts catalog
Registration card

Installing the Cutting Units

Cutting unit models 03860, 03861, and 03862 can be
installed at any of the seven mounting locations on the
traction unit. Figure 2 shows the orientation of the
hydraulic drive motor for each of the five locations. For
any of the locations requiring the motor to be mounted on
the right end of the cutting unit, install a counter weight on
the left end of the cutting unit. For the locations requiring
the motor to be mounted on the left end, install a counter
weight on the right end of the cutting unit.
Note: Counterweight mounting capscrews are shipped
installed on the right bearing housing of the cutting units.
The capscrews on left bearing housing are to be used for
securing the hydraulic motor.
Qty. Use
7
Mounting the counterweights and motors to the
cutting units.
12
7 Mounting the cutting units to the traction unit
7 Locking the cutting units
Diagnosing machine malfunctions (store in
1
service shop until needed)
1 Use with hood lock
1 Contains keys
1
Setting cutting units, refer to Cutting Unit
2
Operator's manual
2
4 Apply to machine for CE
2
2 Read before operating the machine.
1
1 Fill out and return to Toro.
Motor Weight Weight*
#4
Motor Weight*
#2
Motor Weight
#6
* With speed sensor
1. Remove cutting units from cartons. Assemble and
adjust per Cutting Unit Operator's Manual.
12
Motor Weight Motor
#1 #5
Weight Motor
#3
Weight Motor
#7
Figure 2