Specifications; General Specifications - Toro Reelmaster 6700-D Operator's Manual

Specifications

Note: Specifications and design subject to change without notice.

General Specifications

Engine
Main frame
Cooling system
Fuel system
Traction system
Ground speed
Cutting unit drive system
Seat
Steering system
Tires
Brakes
Electrical features
Controls
Gauges
Diagnostics
Kubota four cylinder, over head valve, liquid cooled, turbo diesel engine. 42.5 hp @
3000 rpm. Governed to 3200 rpm. Heavy duty, 3-stage, remote mounted air
cleaner. High water temperature shutdown switch.
All welded formed steel frame, includes tie-down loops
Radiator capacity is approximately 10 qts. (9.4 l) of 50/50 mixture of ethylene glycol
anti–freeze. Remote mounted 1 qt. (.9 l) expansion tank. Removeable oil
cooler/radiator intake screen. Air to oil cooler, mounted to front of radiator, tips
forward for cleaning
Servo-controlled hydrostatic system driving double planetary gear reduction front
wheel drives. Foot pedal control of forward/reverse ground speed.
Toro 4-Matic 4-Wheel Drive System only: Rear drive axle coupled to hydrostatic
transmission via overrunning clutch for full time on-demand 4 wheel drive. A Roll
Over Protective Structure (ROPS) and seat belt are standard.
0–10 MPH forward, 0–4 MPH reverse
Reel motors feature quick disconnect for removal or installation onto cutting unit.
Cutting units can be driven from either end.
Deluxe high back suspension seat with adjustable fore and aft travel, weight and
height. Tool box at left side of seat.
Power steering with dedicated power source
Two rear steering tires: 20 x 10.00-10, tubeless, 6-ply rating. Two front traction
drive tires: 29 x 14.00-15 tubeless, 6-ply rating. Recommended tire pressure for
front and rear tires is 15–20 psi.
Individual totally enclosed, multi-disc, wet brakes and parking brakes on front
traction wheels. Hydrostatic braking through traction drive.
12 volt, 530 cold cranking amperes at 0 F (–18 C), 85 minute reserve capacity at
80 F (27 C), maintenance free battery. 55 amp. alternator with l.C.
regulator/rectifier. Automotive type electrical system. Seat switch, reel and traction
interlock switches.
Foot operated traction and brake pedals. Hand operated throttle, speed control
lever, parking brake lock, ignition switch with automatic preheat cycle, single joy
stick control for cutting unit on/off and lift lower. Cutting unit backlap switch located
under hood. Height-of-cut selector knob located under control panel.
Hour meter, speedometer, fuel gauge, temperature gauge, 4 bank warning lamp: oil
pressure, water temperature, amps, and glow plug.
The Automatic Control Electronics, ACE
of machine functions for maximum reliability. Optional diagnostic display connects
to an electronic control unit to pin point any electrical problems quickly and easily.
Available DATA LOG system allows mechanic to find intermittent problems.
10
system allows precise timing and control