Operation; Controls - Toro Reelmaster 6700-D Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Controls

Traction Pedal
The traction pedal (Fig. 22) controls forward and reverse
operation. Depress top of pedal to move forward and
bottom to move backward. Ground speed depends on how
far pedal is depressed. For no load, maximum ground
speed, fully depress pedal while throttle is in FAST.
To stop, reduce foot pressure on traction pedal and allow it
to return to center position.
Forward Speed Limiter
Preset the forward speed limiter (Fig. 22) to limit the
amount the traction pedal can be depressed in the forward
direction to maintain a constant mowing speed.
5
6
7
9
8
Figure 22
1. Traction pedal
2. Forward speed limiter
3. Red control light
4. Speedometer
5. Brake pedals
Red Diagnostic Light
When the red diagnostic light (Fig. 22) flashes, it may
indicate that the machine is being operated faster than the
maximum speed value initially programmed into the ECU.
The light will also flash if an electrical malfunction has
been detected and when glow plugs are on.
4
2
1
3
6. Parking brake latch
7. Locking pin
8. Reverse speed limiter
9. Key switch
21
Key Switch
The key switch (Fig. 22) has three positions: OFF,
ON/Preheat and START.
Speedometer
The speedometer (Fig. 22) indicates ground speed at which
machine is traveling.
Brake Pedals
Two brake pedals (Fig. 22) operate individual wheel brakes
for turning assistance, parking, and to aid in obtaining
better sidehill traction. Locking pin connects the pedals for
parking brake operation and transport.
Parking Brake Latch
A knob on the left side of console actuates parking brake
lock (Fig. 22). To engage parking brake, connect pedals
with locking pin, push down on both pedals and pull
parking brake latch out. To release parking brake, depress
both pedals until parking brake latch retracts.
Reverse Speed Limiter
Adjust the screw (Fig. 22) to limit the amount the traction
pedal can be depressed in the rearward direction to limit
speed.
Lower Mow/Raise Control Lever
(Joystick)
The lever (Fig. 23) raises and lowers the cutting units and
also starts and stops the reels.
Fuel Gauge
The fuel gauge (Fig. 23) indicates level of fuel in tank.
Engine Oil Pressure Warning Light
This light (Fig. 23) indicates dangerously low engine oil
pressure.
Throttle Control
Move the control (Fig. 23) forward to increase engine
speed, rearward to decrease speed.
Engine Coolant Temperature Warning
Light
The light (Fig. 23) illuminates and the engine shuts down
when the coolant reaches a dangerously high temperature.